How To Install The Pure Plus Pro Under Sink Filtration System

Hi, Cam here with a quick video on how to upgrade your existing under sink filtration system
to our new Pure Plus Pro Upgrade Kit.

The Upgrade Kit includes a high capacity Carbon Block Filter to remove up to ninety nine
percent of all the incoming chlorine the cartridge is also rated to remove parasitic cysts such
as Cryptosporidium and Giardia.

The unique sanitary change head connection allows for quick and stress-free filter changes.

The space-saving design of the PPP cartridge incorporates the actions of 3 filters 

within one, allowing more space under bench to be utilised forkitchen items as well as 

minimising the effect on the environment once discarded.

The sanitary quick-change filter technology used in the Pure Plus Pro System provides 

a quick and easy way to change the filter cartridge without the need for tools, towels or buckets.

A twist of the cartridge and the filter is removed and replaced making it the choice for many

DIY homeowners.

If you are finding it difficult to source reasonably priced replacement filter cartridges for your existing filter system or if undoing your existing filter housing has just become too difficult, 

the Pure Plus Pro Upgrade Kit is the solution you could be looking for.

And now I can show you how easy it is to install the upgrade kit, first identify the point of your incoming water, there should be a stop valve located before the filter line starts, simply 

turn it to the off position, move across to your faucet on top of the sink there, by opening 

this up and allowing the water to flow out freely you're actually depressurising the system, 

making it safe to undo the bottom casing.

Using a set of tube cutters or sharp Stanley knife, mark out about a quarter of an inch

away from the filter housing and just snip that tube line.

Carry that out on both sides.

You can then remove the old filter housing, what you want to do here is just inspect the

thing has been cut straight, if it hasn't for any reason, come back in about 5 millimetres

and just cut that nice and straight, this will help join the tubing to the filter head.

Do that on both sides, then grab the filter head, the filter head has markings on it to

show which one is the inlet and which one is the outlet, in this case we are going to

connect the inlet first, so grabbing the tube, push that into the quick connection on the

side and that will go in about five millimetres, you can be certain that is secure by pulling

back on it and then do that on the other side for the outlet, both those connections are

quite strongly put together, you can see by me pulling away here that they are not going

to come out.

We can now take the filter cartridge and remove the red safety cap, take the cartridge

and fit it all the way into the base of the filter head, push that up as far as it can

go and then turn clockwise, that will ensure it is nicely seated in place, go back through

to the isolation tap that's been turned off at this time and turn it to the on position,

this will allow the water to flow back into the cartridge again and you should be able

to hear it move through there quite quickly, you want to leave that about a minute or two

and just double check all of the connection points and make sure that there are no leaks

happening.

Move through to the faucet and turn the faucet on, what will happen initially

is that there will be some white and grey material that will come through and the glass

will look almost milky when it fills up, that's just air being released from the filter cartridge

and is perfectly safe. once that stops after about five litres, you can simply turn the

filter tap back off again and the system is ready to use.

Thanks for watching and don't forget to like and subscribe for more videos.

Name: Discount Fridge Filters
Phone: 1300 115 754
Website: https://discountfridgefilters.com.au/